Accessories - McNett - Aquaseal® Urethane Repair Adhesive & Sealant
 Order at bottom of page
Aquaseal® Urethane Repair Adhesive & Sealant
The industry standard for maximum strength repairs to wet suits, dry suits and all watersports products. Flexible
urethane formula waterproofs, seals and protects against abrasion. Hundreds of watersports and household uses.
For fast cure, use with Cotol-240™ Cure Accelerator.
DIRECTIONS FOR NEOPRENE REPAIR:
Clean damaged area with
Cotol-240™ Cure Accelerator/Precleaner or solvent (paint thinner, nail polish
remover or similar). Trim loose threads. Non-fabric surfaces should be roughened with sandpaper, then cleaned.
Apply Aquaseal® to surfaces directly from tube or with knife or flat stick. Keep repair level overnight.
Avoid contact with other surfaces. Most repairs reach full strength overnight (10–14 hours). Allow longer for thickest
repairs. For fastest cure (2 hours or less), mix in Cotol-240.
HOLES AND TEARS: Create backing
with removable tape. Fill void and 1/4” beyond edge with Aquaseal. Remove tape after full cure.
SEAMS:
Apply 1/16” thick bead overlapping seams edges by at least 1/4”. Apply with slight pressure to saturate
fabric surfaces.
HIGH WEAR AREAS: Apply thin coat with knife for flexible abrasion resistance.
WARNING: FULLY CURED AQUASEAL IS SLIPPERY WHEN WET. For added traction on footwear, sprinkle sand
on uncured Aquaseal 1/2 hour after applying.
CLEAN UP: To remove Aquaseal from hands, buff with
cloth soaked in paint thinner, nail polish remover or 99% isopropyl alcohol.
STORAGE: Advance
contents to tube neck. Wipe clean and cap. Keep in cool, dry place; for extended life, place in freezer. To thaw or
for easier-flowing contents, soak tube in warm water for 15 minutes.
Order Below
|
|
|
