Cotol-240™ Cleaner & Cure Accelerator
is a urethane cure accelerator and pre-cleaner to be used in conjunction with Aquaseal®. The solvent
cleans and prepares the surface, readying it for Aquaseal®, speeding the
tack time to 15 minutes and the full cure time to less than two hours. Cotol-240 is also ideal for removing tar, sap,
glue, and other resins from various surfaces including glass, plastic and metal. Available in ½ oz. Blister Pack, 4 oz.
and Quart (not shown).
Cotol-240™ Directions for use with Aquaseal®
Repair Adhesive and Sealant:
AS PRECLEANER:
- Apply a small amount to the damaged area (spot test for colorfastness).
- Rub with a clean cloth until dry.
- Repeat steps 1 and 2.
- Apply Aquasure as directed.
Note: for best adhesion, first roughen non-fabric surfaces with sandpaper.
AS CURE ACCELERATOR:
- Thoroughly mix 1 part cure accelerator with 3–4 parts Aquaseal® using a stick, toothpick, or knife. Mix on a non-absorbent surface such as a plastic lid or plate.
Immediately apply the mixture to the damaged area.
Allow the repair to completely cure at least 2 hours before using.
CLEAN-UP: To remove Aquaseal® from hands, use cloth soaked with paint thinner, nail polish remover or 99% isopropyl alcohol.
STORAGE: Cap tightly. Store in cool, dry place. Use blister card package for storage.
Order Below
|
